VFC/Umarex Glock Gen 5 Magwell - Airsoft & RS
Print Profile(2)
Description
Membership
Want to sell physical prints of this model? Join my membership today!
Welcome to Adyz Tactical Prints !
Print Ready & Optimized Orientation For Best Results
- Compatibility: ONLY AIrsoft Umarex Glock Gen5 17&45 (MOS not supported) and Real Gen5 (Europe versions)
- Hardware: Optional 5x10mm grub screw, m3 thread insert + m3 bolt
- Recommended Filament: PETG HF/CF
- Support/Brim: YES/No (sliced & ready to print)
- Quick Tip: It helps if you push the insert further and then push it down through the frame hole at the back.
- Short Info: Place the insert in the grip as shown in the picture then the magwell on the front lip of the grip as shown in the picture, with your thumb push the back of the magwell forward and down until it snaps in place on the insert. Done.
Remixed from: https://makerworld.com/en/@user_624941137
⚠️⚠️⚠️ If the model falls off during printing, your plate needs a wash with warm water & dish soap.
Avoid glue for PLA !
Guide: Bambu Lab Cleaning Guide.
All projects are printed and tested on P2S using Bambu Lab filaments for best results.
Print Questions or Issues? Send me a PM, I'm here to help !
⭐⭐⭐⭐⭐ If you like it, please rate & share a photo !
🚀 Boosts help me buy filament and test print more cool stuff.
📸 https://www.instagram.com/adyztacticalprints
“Calibration is key for 0.1mm tolerances.” - ATP
Membership
Want to sell physical prints of this model? Join my membership today!
This remix is based on
License
Comment & Rating (113)