Lamp Kit LED Tea Light Base
Boost
128
229
32
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
33 min
1 plate
Boost
128
229
32
0
261
182
Released
Description
The Lamp Kit Base with supports to hold and center a tea light. The space should accommodate a 37mm diameter tealight.
Comment & Rating (32)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
while the print itself looks fine, the description should maybe include brand or diameter etc of the led tea light, as I have 2 different cheap models, and both are the same size and too wide to fit. I did try and push it a bit in, but halfway it was just bending too much at the bottom half that it was very clear it would never fit. Must see if I spot some smaller ones somewhere.
The designer has replied
0
Reply
Hi,
I'm sorry you've had an issue with the tealights fitting. The lights I've sourced from different sources in the US have been 37 or 38mm consistently. I'll update the description.
(Edited)1
Reply
Replying to @gartnix
Would you by chance be able to make a tea light base that could take 38 mm wide by 18 mm tall led tea lights? :-) Ah just saw you mentioned 37/38 mm, but when I printed it kinda looked like it is a few mm less than that, trying to fit in the light. Just measured the one I printed. Maybe shrink during print, but it is more like 36-36,5 mm. But led light is 38 mm, so would need at least another 1,5 or 2 mm between led light holders.
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
the print was successful but my lights don't fit. I'll do a remake for the D37 mm lights
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
parfait 👍
0
Reply
This model is as the original?
The designer has replied
0
Reply
This model is a remix of the original. The only change is from the LED module that comes in the Kit to a tealight that is commonly available.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfect !
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
nice
0
Reply
This LED support does not allow 37 mm diameter lights to be accommodated. the seat is 36 mm.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Related Models
© 2024 MakerWorld