Ikea Skadis Ring holder - Pegboard ring holder
Boost
8
18
4
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
43 min
1 plate
Open in Bambu Studio
Boost
8
18
4
0
23
11
Released
Description
A simple ring holder for your Ikea Skadis pegboard.
Safely store your rings.
Printed in PLA with a brim for the back hooks, no supports needed.
3mf file has a modifier applied to strengthen the hooks (not essential but helps)
Comment & Rating (4)
All
The SKADIS interface for these is garbage. A mere 28 grams of downward force is enough to lever the whole piece downward and eject it from the board. Furthermore, the design is wasteful, with a full rectangular platform that is not necessary to support rings.
Do not print this. It doesn't suit its intended purpose at all.
1
Reply
should have read that before printing. same for me. hooks do not work.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I don’t know for which skadis version this was made, but this model does not hold on it. the holders are to thick.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld