Necklace, Ring, and other Jewelry Holder
Boost
46
96
17
Print Profile(1)
0.2mm layer, 15% infill, normal supports
Designer
1.6 h
1 plate
Boost
46
96
17
0
100
126
Released
Description
This can hold a couple of your necklaces plus some rings or hair ties on the top. I used some scotch double-sided mounting strips to keep it up and it is really working and holds a good amount of weight if you have heftier necklaces. Command strips would probably work too and are more renter-friendly. I used regular pla and it's been working perfectly.
Comment & Rating (17)
All
Print Profile
0.2mm layer, 15% infill, normal supports
Printed beautifully in PLA. Supports came out nice and easy 👍
0
Reply
Print Profile
0.2mm layer, 15% infill, normal supports
looks very nice out of pla-cf. Works perfectly. Supports came of very easy with no marks left. Would recommend printing on the textured pei plate so the tape or glue has more grip on the printed part
0
Reply
Print Profile
0.2mm layer, 15% infill, normal supports
(Edited)
0
Reply
Print Profile
0.2mm layer, 15% infill, normal supports
My sister loved it she hung it up on her wall and it holds so much stuff, and it printed out great.
0
Reply
Print Profile
0.2mm layer, 15% infill, normal supports
printed great and works great
0
Reply
Print Profile
0.2mm layer, 15% infill, normal supports
it printed great without any issues
0
Reply
Print Profile
0.2mm layer, 15% infill, normal supports
very nice model! Happy Wife, Happy Life! thanks for sharing!
0
Reply
Print Profile
0.2mm layer, 15% infill, normal supports
0
Reply
Print Profile
0.2mm layer, 15% infill, normal supports
0
Reply
Print Profile
0.2mm layer, 15% infill, normal supports
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld