If you cannot see the video, please click here

The design of this wireless charger comes from the Airforce Command Headquarters in the classic game "Command & Conquer: Red Alert 2". It perfectly recreates the animated effects from the game, including radar rotating and lights flashing. The overall dimensions are 14cm x 10cm x 12cm. It features two power modes: low power mode ranging from 0 to 5 watts and high power mode ranging from 5 to 15 watts. If you intend to use the high power mode, it's recommended to use temperature-resistant filament for printing, such as ABS or ASA.

This model is fully compatible with the Wireless Charger Kit-K012 released by Bambu Lab. Additionally, you only need to prepare glue and a screwdriver to complete the installation.

Hardware Kit: Wireless Charger Kit

Disclaimer:This model is part of the Creator Program, When you purchase the Wireless ChargerKit K012 through the links below, creators may earn an affiliate commission as a reward of their work. (The creator program is currently in the trial phase. The application is not yet open to public.)

If you don't have AMS, you can also complete the printing of multi-color parts according to the following steps:

Step 1.Set Z hop when retract in the filament settings to 0.4 or above.

Step 2.Place the multi-colored side facing down, at the edge of the hotbed, avoiding covering the center of the hotbed, then split to objects.

Step 3.By deselecting the printable option, retain only one color and print.

Step 4.After the printing is completed, keep the hotbed still and replace it with another filament. Use the same method to print another color. Be careful to cancel the Bed Leveling this time.

Step 5.Repeat the above steps until the printing is complete.

Enjoy printing.