Audi Flame Hueforge
Copyright Claim
Audi Flame Hueforge
Boost
10
15
2
Print Profile(1)
0.08mm layer, 2 walls, 100% infill
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
10
15
2
0
23
10
Released
Description
Made a nice picture of an Audi into a cool hueforge picture
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA Gereric Black
PLA Gereric Red
PLA Gereric Yellow
PLA Gereric White
Swap Instructions:
Start with Black
At layer #6 (0.56mm) swap to Red
At layer #10 (0.88mm) swap to Yellow
At layer #16 (1.36mm) swap to White for the rest.
All comments, suggestions and ideas are welcome.
GLHF
Comment & Rating (2)
All
Print Profile
0.08mm layer, 2 walls, 100% infill
it prints fine but mine ended up with too many rings for the Audi logo
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
sieht gut aus nur sind 2 Ringe zu viel
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld