This is a remix of - https://www.thingiverse.com/thing:2753151

This fit's the BL Touch smart or the 3D Touch on the Wanhao I3 Plus or it's offspring.

Fit's very tight between the DiiCooler and the EiiCooler

I made it to fit the left hand side with a front fan housing

I added extra room for the fan housing and added a small support and a cutout to allow the wires to come thru.

I added the Spring Cup version with cutouts for the Springs that come with the BL Touch

And I just added the V2 version that adds extra support.

New Version V3 has even more support for flex issues and updated longer spring cups, if they are too close to the bed in height just adjust Z offset in menu or sand it down slightly.

Version V3,1 Slightly shorter then V3 but longer then V2.

Should be a good fit as is

You can also use my calibration block with it to set your sensor pin height correctly to know what spacers you need.

Print Settings

Printer Brand:

Wanhao

Printer:

No

Supports:

.1

Infill: