LOVE IT!!!! Just switched to a Manta M5P (IFYKYK D3D) and needed to raise my K1 Max just a little bit more to give the Board room to breathe, and to stabilize it for higher accels too. My recommendations for the K1 Max are to make a 3.2 mm version (it was tough, but I made it work), and to change the chamfer/fillet just a little bit to print better on the side. Or I would recommend supports or printing REALLY REALLY SLOW to prevent saggy/warping overhangs at the beginning of the print. These things are CHONKY! They are not going anywhere. Thanks for your work, and great design as always!
They work great! Make sure to print the test prints and to read the github page! You may need to make some adjustments to get things to fit but once they are on there, they are solid! Thank you Derrick!