这是我很早之前设计的，一款简单的用于挂置在“宜家skadis置物板”的圆形遥控器底座，用于遥控“米家屏幕挂灯”。同样的，1s款的遥控器也可以适用。（请不要在意我的实物图，我选用了另一种置物板，我上传的文件是支持skadis和大部分孔网间距35mm，孔网宽度5mm，孔高10mm的置物板的。）

我非常建议进行倒置打印，即将平面向下，挂钩向上的方式打印。这会使得支撑很少（是的，这需要支撑*），并且在拆除之后，将遥控器放置在上面会将支撑的水口痕迹掩盖掉（yeah）。

推荐使用pla打印，我没有尝试过petg。

取出时可以从底部的孔洞推出遥控器。如果无法取出，你可以在底部弧面的边缘找到一条细缝，并从此处暴力拆除。

再次强调：

关键词：#mijia屏幕挂灯 #宜家skadis置物架

是否需要支撑：是（部分）

材料：pla（其他材料未尝试）

相关参数：适用孔网间距35mm，孔网宽度5mm，孔高10mm的置物板。适用直径ø66.5mm的圆形遥控器。

This is a simple round remote control base that I designed a long time ago to hang on the IKEA skadis shelf for remote control of the Mijia Display Lamp. The same applies to the 1s remote control. (Please don't mind my pictures, I chose a different type of plate, the file I uploaded supports skadis and most of the plates that have 35mm mesh spacing, 5mm mesh width, and 10mm hole height).

I highly recommend printing upside down, i.e. plane down, hooks up. This will leave very little support (yes, it needs support*), and placing the remote on top after removal will hide the support spout marks (yeah).

Pla printing is recommended, I haven't tried petg.

To remove it you can push out the remote through the hole in the bottom. If you can't remove it, you can find a thin slit on the edge of the curved bottom surface and remove it destructively from there.

Again, emphasis added:

Keywords: #mijia display hanging light #Ikea skadis shelf

Does it need support: yes (partially)

Material: pla (other materials not tried)

Relevant parameters: Applicable hole mesh spacing 35mm, hole mesh width 5mm, hole height 10mm shelves. Suitable for round remote control with diameter ø66.5mm.

(Mechanical translation, if there is a misunderstanding can be commented.)