A levitating heart for your sweetheart.
For a better effect of levitating hearts, I recommend using the possibility of changing the filament, I used clear PLA from Nebula. Alternatively, you can use MMU or AMS, depending on the capabilities of your printer.
I tried to use as few fibers (strings) as possible, so that the impression of the floating hearts was as good as possible.
Printed with a layer height of 0.2mm, 10% infill, no supports.
For correct “string” printing, you need to have the "perimeter wall generator" set on Arachne.
I also recommend taking your time to remove the finished print from the mat to avoid tearing the fibers. In my case, after cooling, the model bounced off the mat without any damage :-)
I used the great Valentine Rose of Love od autora ArgiCZ to decorate the stand.
Feel free to share your prints. Thanks :-)
--------
Levitující srdce pro Vašeho miláčka.
Pro lepší efekt levitujících srdcí, doporučuji využít možnost změny vlákna, já použil čiré PLA od Nebuly. Případně můžete využít MMU či AMS, dle možností Vaší tiskárny.
Snažil jsem se použít co nejméně vláken (stringů), aby dojem ze vznášenjících se srdcí byl co nejlepší.
Vytištěno s výškou vrstvy 0,2mm, 10% výplň, bez podpor.
Pro správný tisk vláken, je třeba mít při slicování nastaven “generátor obvodových stěn” na Arachne.
Doporučiji také nespěchat se sundáním hotového výtisku z podložky, abyste si nepotrhaly vlákna. V mém případě po vychladnutí model sám z podložky odskočil bez jakéhokoli poškození :-)
K ozdobení stojánku jsem použil skvělý design Valentine Rose of Love od autora ArgiCZ.
Neváhejte se podělit o své výtisky. Díky :-)