screw pill box
Copyright Claim
screw pill box
Boost
62
116
30
Print Profile(2)
CAP, vase mode, 0.2mm layer
Designer
28 min
1 plate
TRAY, 0.4mm nozzle, 0.2mm height
Designer
40 min
1 plate
Open in Bambu Studio
Boost
62
116
30
5
174
248
Released
Description
A simple 7-compartment pill box/organizer for a week. The cap screws off to open one compartment after another.
The tray's bottom is flat, so it doesn't roll away when loading, also for easy printing.
The cap is printed in vase mode and doesn't need much filament.
Screwing the cap on and off may be rough for the first few times, but after a bit of breaking in goes smoothly. However, if the cap is to loose or to tight, reprinting it slightly scaled up or down (X and Y axis, by a fraction of a percent) doesn't produce much waste (4g of filament).
Comment & Rating (30)
All
Print Profile
CAP, vase mode, 0.2mm layer
perfect foe the purpuse, tiny and handy
2
Reply
Boosted
Print Profile
TRAY, 0.4mm nozzle, 0.2mm height
It is simply perfect. Small, securely closed, quick and easy to print. There is a boost
0
Reply
Print Profile
CAP, vase mode, 0.2mm layer
Worked great. I had no issues and it fit perfectly on printing
0
Reply
Print Profile
TRAY, 0.4mm nozzle, 0.2mm height
Printed without issue and mated perfectly with the cap.
0
Reply
Print Profile
TRAY, 0.4mm nozzle, 0.2mm height
Practical and perfect!
(Edited)
0
Reply
Well it was a good exercise in reading instructions first. Understanding vase mode makes sense now
(Edited)The designer has replied
0
Reply
This model does not need supports.
0
Reply
Print Profile
TRAY, 0.4mm nozzle, 0.2mm height
simple and easy to use
0
Reply
I was about to design almost exactly this. Very cool.
0
Reply
Print Profile
CAP, vase mode, 0.2mm layer
Practical and perfect!
0
Reply
best design I have seen so far! great job!
0
Reply
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld