EIBOS Polyphemus removable Desiccant Container by raeuberhose

raeuberhose

3D Printer>3D Printer Accessories

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

ABS/ASA profile, 0.2mm layer, 2 walls, 12% infill

Designer

1.8 h

1 plate

5.0(21)

PETG 0.2mm layer, 2 walls, 12% infill

1.8 h

1 plate

5.0(3)

Open in Bambu Studio

Boost

105

Released

Description

This is a desiccant container for the EIBOS Polyphemus filament dryer. It can contain up to 35g of desiccant each.

To open up the closed container, squeeze the rear of the box lightly and lift up the lid.

When inserted into the desiccant tray of the EIBOS, lock the container with the clip, just like the original tray cover.

Best printed in ABS/ASA or PETG, or other heat resistant filaments.

Comment & Rating (34)

@HardwareMaster

Print Profile

ABS/ASA profile, 0.2mm layer, 2 walls, 12% infill

Great print! Works perfectly. Thanks!

@jrwagz

Print Profile

ABS/ASA profile, 0.2mm layer, 2 walls, 12% infill

printed great in Bambu ASA, thanks for sharing!

@Moth

Print Profile

PETG 0.2mm layer, 2 walls, 12% infill

Works really well and printed great.

@qinty

Print Profile

ABS/ASA profile, 0.2mm layer, 2 walls, 12% infill

Printed on a P1S, with BambuLab ASA.

@Kingmob

Easy to print and fit, well designed and sturdy. Printed in white ASA.

@HardwareMaster

Would PLA still work but not as long as the others would?

The designer has replied

@raeuberhose

I don't know if the heat in that area is high enough for it to soften PLA when drying PLA or PETG. I would assume, if you start drying Nylon e.g. it will fail. PLAs stiffness is another factor. The latch on the backside of the lid has to deform a bit. I haven't tested PLA over a longer period, it might snap when removing the container. PLA can possibly work, however I would at least use PETG, just to be safe.

@HardwareMaster

Replying to @raeuberhose :

thanks. i will try ASA I think, I got TPU as well but it is not too much better than PLA.

@HardwareMaster

It was my first time with ASA and took a few tries with adhesion to my own fault but it worked at the end once I used some glue and the right plate, lol :) Thanks a bunch! fits and works perfectly.