Dosierlöffel 30ml Everdrop / detergent spoon everdrop 30ml
Copyright Claim
Dosierlöffel 30ml Everdrop / detergent spoon everdrop 30ml
Boost
6
13
30
Print Profile(2)
0.2mm layer, 2 walls, 15% infill, tree support
Designer
36 min
1 plate
0.2mm layer, 2 walls, 15% infill
42 min
1 plate
Open in Bambu Studio
Boost
6
13
30
1
59
73
Released
Description
Ich habe einen Dosierlöffel für die everdrop Waschmittel kreiert, welcher ein Volumen von 30ml hat.
I created a dosing spoon for the everdrop detergent, which has a volume of 30ml.
Comment & Rating (30)
All
Print Profile
0.2mm layer, 2 walls, 15% infill, tree support
Gutes, minimalistisches Design. Besten Dank.
The designer has replied
0
Reply
Danke für deine Bewertung ☺️
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, tree support
Great for the laundry soup and booster. Scaled one down to about a tablespoon. Great job!
The designer has replied
0
Reply
Thank you very much ☺️
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, tree support
Printed perfectly using polymaker PLA, thanks!
The designer has replied
0
Reply
Thank you so much for your rating :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, tree support
works great
The designer has replied
0
Reply
Thank you very much :)
(Edited)1
Reply
Darf ich den auch für Proteinpulver verwenden? ;)
The designer has replied
0
Reply
Du kannst es ausprobieren. Beachte bitte Lebensmittelfestes Material zu nutzen und bedenke, dass durch die entstehenden Rillen beim 3D Drucken weniger Hygiene da ist und eine erschwerte Reinigung.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, tree support
Very thick walls not great to use imo
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, tree support
The designer has replied
0
Reply
Thank you ☺️
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, tree support
The designer has replied
0
Reply
Thank you very much :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, tree support
The designer has replied
0
Reply
Thank you very much for rating ☺️
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, tree support
The designer has replied
0
Reply
Thank you 👍
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld