PrintHub Magnet
Copyright Claim
PrintHub Magnet
Boost
133
152
29
Print Profile(1)
Ironing: 0.4mm layer, 2 walls, 15% infill
Designer
27 min
1 plate
Open in Bambu Studio
Boost
133
152
29
0
282
203
Released
Description
Print Hub Logo I made, similar to a websites logo.
Letters are 1mm higher than the rest, for one extra layer of color.
Holes are designed for two 6mmx2mm magnets.
Comment & Rating (29)
All
Print Profile
Ironing: 0.4mm layer, 2 walls, 15% infill
Awesome print! It’ll go perfect right above my printers. whoever thought of this is great! You’re hilarious! I did however scale it up a little because the first print I tried to scale it down and you could see the black bleed through the orange so after I scaled it up past the normal settings it looked and print great in a short amount of time as colored prints go.
The designer has replied
2
Reply
Thank you very much! ☺️
0
Reply
wow nice setup! Did you print all those figures and the shelves for them too?
0
Reply
Print Profile
Ironing: 0.4mm layer, 2 walls, 15% infill
Quick little print.
0
Reply
Print Profile
Ironing: 0.4mm layer, 2 walls, 15% infill
Nice model.
0
Reply
Print Profile
Ironing: 0.4mm layer, 2 walls, 15% infill
They turned out great! Thanks :)
0
Reply
Nice
0
Reply
Print Profile
Ironing: 0.4mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Looks great! 🔥
0
Reply
Print Profile
Ironing: 0.4mm layer, 2 walls, 15% infill
1
Reply
Print Profile
Ironing: 0.4mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Ironing: 0.4mm layer, 2 walls, 15% infill
glued to the door of my x1c haha
1
Reply
Print Profile
Ironing: 0.4mm layer, 2 walls, 15% infill
genial :-D
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld