The LC12B1 is a great car. I thought I'd try to give it a little more flex, similar to modern 1/10th 4WD's. I've used the mod a few times on primafelt carpet and runs well, the chassis does have quite a bit of flex now, which maybe too much. The car ran well for me.

Takes the original posts if needed, but you dont use the original body posts then you dont really need to print the rear mount. Just the front and middle.

Uses all the original bolts.

Print Settings

Printer Brand:

Creality

Printer: 

Ender 3

Rafts:

No

Supports: 

No

Resolution:

0.2

Infill: 

High

Notes:

I'd recommend PETG or ABS as PLA may warp if it gets too warm inside the shell. Maybe ok, always used PETG for stuff like that.

Category: R/C Vehicles