Nice print!

I printed all the colors it turned out great

You printed it very well, including the hanging wiring on the "feet" which are the most critical part.

Thank You

Hi, if you have this problems you can try this: Degrease: wash the build plate with soap, a soft sponge and rinse well with hot water. do not touch the printing surface with your fingers. Glue: If you use the cool plate, always put an even layer of glue stick on the part where you will print. Temperature: if the default temperature of the build plate is 35° and the filament does not attack, increase the temperature even up to 50° (I remember that in old printers it was impossible to print with the build plate at less than 60°) Calibration: bed calibration should be done every time you turn on the printer (...even if I only do it when I change the type of plate...). Change build plate: The cool plate usually has some replacement stickers, you can replace the old one with a new one. Even better if you buy the textured pei plate, the golden one: it's exceptional!

I'm going to do that this weekend when I'm off work. I think you're figure is awesome. thank you for the advice.

I just got it before Christmas, I hope its still OK. lol

Me too! Thank a lot

Hi @ileonrd , thanks for your boost.

Thank you