Echo Show 5 under cabinet holder by madd0g

madd0g

Household>Other House Models

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

UPDATED CORRECT ORIENTATION 0.2mm layer, 2 walls, 15% infill

Designer

1.6 h

1 plate

2.0(1)

Open in Bambu Studio

Boost

Released

Description

Easy to print solid Holder to mount your echo show 5 under a cabinet, oder shelf.

Use 20x10x2mm magnets in the bottom slots to secure the Echo.

Atention, updated Profile, part must be printed on its side, due to strength requirements.

Comment & Rating (5)

@GearsOfDarkness

The print profile is no longer public

Excellent print. Very strong. I mounted my unit under the cabinet. The only item I would add is a place to hold the extra cable - maybe a remix in the future?

(Edited)

Support Issue

Strength Issue:it broke. I printed again using a much higher infill (55%). hope it holds.

The designer has replied

@GearsOfDarkness

Unfortunately I need to downgrade my rating to a 2 Star. Worked good but broke! Needs some extra strength in the smaller portion that holds the Echo. What is the purpose of the notches in the bottom?

@madd0g

Replying to @GearsOfDarkness :

Just checked the 3mf file, and nitces it is oriented in the wrong way, make sure you print it on its side. Will upgrade the print profile, Always check that the layers are not in the load direction. The direction of the load, should always be a full profile. The notches are there to glue the two 20x10x2mm magnets as per the description.

(Edited)