X1C storage System by Big-Daddy

Big-Daddy

3D Printer>3D Printer Accessories

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

24 h

4 plates

4.8(34)

Open in Bambu Studio

Boost

216

384

400

194

Released

Description

This is my version of a X1C storage looks like the actual printer. Has 6 drawers with supportless handles. The screen you can screw on using 3mm screws or super glue I used m3 x 8mm.

the top under the lid is 29mm deep, 129mm wide, 140mm long, the 2 drawers' inner diameter is 54.5mm, tall 137.5mm, 40.17mm wide the 2 middle drawers are 22.38mm tall, 137.5mm long, 54.5mm wide the bottom 2 drawers are 22.7mm tall, 137.5mm long, and 116.5 wide at it present scale. 2pcs. need support the handle knob for the top lid (glass plate) and the top of the main body where the top lid goes on there is a set of 4 feet you can print in PLA or TPU you can pop on the bottom. Happy printing and thanks for looking.

For the P1P or P1S version

https://makerworld.com/en/models/177780#profileId-195603

bambu lab accessories

Comment & Rating (83)

@IceCreamCoffeeV

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed with bambu support for PLA

The designer has replied

@Big.Daddy.

looks great thanks for the rating and boost :)

@IceCreamCoffeeV

Boosted

Replying to @Big.Daddy. :

Top lid asks for a hinge, so I made one with two stripes of electrical tape

@IceCreamCoffeeV

Boosted

👌

@PastAdam

Ripped off my work.

The designer has replied

@Big.Daddy.

it’s not the same total my design not a ripoff

@PastAdam

Replying to @Big.Daddy. :

yes it is, the measurements are all the same either way ive reported you, come up with your own ideas.

@Big.Daddy.

Replying to @PastAdam :

no they aren’t I got all the files for it this is a not your design quit harassing me and just because you deleted your comments it’s stays in my history by the way

@user_3781466832

Boosted

This is so much better than what I was using before. A lot more storage space and better looking.

The designer has replied

@Big.Daddy.

Thank you glad you liked the model

@Knecht74

Print Profile

0.2mm layer, 2 walls, 15% infill

Sehr schönes Modell, lässt sich leicht drucken und sieht gut aus.

The designer has replied

@Big.Daddy.

Vielen Dank für die Bewertung, schön, dass Ihnen gefallen hat, das Modell sieht gut aus

@Ronster

Boosted

Printed perfect, thanks.

The designer has replied

@Big.Daddy.

looks great thanks for the rating and boost glad you liked the model

@user_2902708594

Print Profile

0.2mm layer, 2 walls, 15% infill

lid came out a little small but still works fine. I e printed a few Bambu prints and all have worked well. still using my reality cr10 s as well. now using x1c combo.