Comgrow Z1 Laser Engraver Crosshair Mount
Comgrow Z1 Laser Engraver Crosshair Mount
Print Profile(0)
Description
12mm Crosshair laser mount for the Comgrow Z1 Laser cutter engraver.
Offset from centerline of laser for setting up in Lightburn is X27.07 and Y27.07 You will need to fine tune from there but that is a good starting point and printed right into the top of the mount.
This mount replaces the clear Lexan cover on the top of the laser module and only requires 1 3X8mm screw to clamp the laser crosshair module.
You will have to work out your own power source, I put a long USB cable on mine through the cable chain and run it from the same dock the laser is plugged into. I plug it in for setup then unplug it while burning.
Comment & Rating (0)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
