SpeedyBee Bee35 DJI Action 2 Mount 25°
Remixed by
Copyright Claim
SpeedyBee Bee35 DJI Action 2 Mount 25°
Remixed by
Boost
7
5
4
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.2 h
1 plate
Open in Bambu Studio
Boost
7
5
4
1
12
2
Released
Description
DJI Action 2 Mount für SpeedyBee Bee35 Whoop.
Dieser Mount ist stabiler und zugleich leichter als das beiliegende Teil des Bee35, da hier keine schraube notwendig ist.
Der Winkel liegt bei 25 Grad fix
Am besten mit TPU A95 gedruckt, bei 20mm/s und 240°C (Temperatur kann je nach Filament/Hersteller variieren)
Support wurde auf das nötigste reduziert.
Comment & Rating (4)
All
Nice to see remixes of my design from Printables– but the whole premise of my Action2 project is that it's configurable for every different frame, tilt, filter, etc and make them directly for people!
I support 265 frames, several ND filters, different positions, mounting options, and more. This Bee35 is absolutely one of my supported frames and I've made many configurations for people across the world. Go see my design page! https://www.printables.com/model/217897-t4-max-fov-action-2
(Edited)The designer has replied
0
Reply
You don't have Bee35 on your Page, so I've made one for the community.
More than 25 degree made no sense on this Frame, because the lipo battery is Mounted on the top side, It`s a whoop, not a freestyle kwad.
1
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
thank you 🙏🏼
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld