3DBenchy with 4 colors for AMS
Remixed by
Copyright Claim
3DBenchy with 4 colors for AMS
Remixed by
Boost
20
36
9
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
19.2 h
1 plate
Boost
20
36
9
0
170
28
Released
Description
just an experiment on the famous 3DBenchy on how it would look with 4 colours for the AMS unit.
Be carefull as it will use a lot of poop
Comment & Rating (9)
All
Came out great. Printed on X1C. AMS loaded with Bambu Matte Scarlet Red PLA, Bambu Matte Lemon Yellow PLA, Bambu Basic Green PLA, and Bambu Matte Marine Blue PLA. Took 15.6 hours :)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
the black PLA CF was not a good choice but it was the only black i had
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
good test for ams, but for the amount of wasted filament, it should have 5 models and the 5th be the one that has the changes.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Printed well.. very long print though!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Cool print but I was shocked at how long it took to print and how much waste it created. I had lots of stringing on mine but that can probably be fixed with a little tuning.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld