This can be printed on one plate or four plates (for petals, stem, leaves, and base)
If making any changes, ensure the following:
Petals and leaves have tree supports enabled
Petals and leaves have adaptive layer height enabled
To get the color of the tip of the stem to match the petals, use an AMS or add a pause around height 152.20 to swap colors
From my testing, you may need a tiny bit of pressure to attach the petals to stem and stem to base but it should stay secure
BE CAREFUL WITH THE LEAVES — INSERT THEM INTO THE STEM AT AN ANGLE
For the stamen (center hole at the top of the stem), I’ve tested it to have a snug fit with around 4-6 purge lines (only 1-2 lines needed if you're resourceful with your folding/cutting)
Fold each purge line in half
Insert the folded line into the base until no more can fit
Cut the lines to your desired length
Use your finger to press down into the center hole and fan out the cut lines
Thanks for taking a look! I have the directions for the center of the flower at the bottom of the description but it uses your printer's purge lines
(If you don't have a Bambu printer then I believe you can use 2 short snippets of filament)