Shelf Support Peg by DevopsPalmer

DevopsPalmer

Household>Other House Models

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 3 walls, 15% infill

Designer

23 min

1 plate

4.3(4)

Flush Mounts x4

Designer

24 min

1 plate

Open in Bambu Studio

Boost

Released

Description

Shelf Peg Board Mount - Probably only as auxillary support for shelves if printed in PLA, suggest PETG or ABS if you want a more rigid support. Based around the Prime-Line Clear Plastic, Shelf Support Peg, dimensions should support replacement assuming 5mm hole.

shelves

peg

pegboard

peg board accessories

shelf

shelf bracket

shelf display

Comment & Rating (8)

@para_travis

Print Profile

0.2mm layer, 3 walls, 15% infill

fit nice and snug in the holes and holds the shelf up well with a ~30 pound computer on it

The designer has replied

@devops_palmer

thanks for the rating!

(Edited)

@germy

Print Profile

0.2mm layer, 3 walls, 15% infill

Printed great, some of the pegs were a little wide and took some elbow grease to get in.

The designer has replied

@devops_palmer

Thanks! it definitely does print snug, I will do a few more test fits of different diameter and length and see if any offer similar strength with less elbow grease required

@Ryan.thomas369

Print Profile

0.2mm layer, 3 walls, 15% infill

peg was to small

The designer has replied

@devops_palmer

the peg should be for the exact linked replacement and for 5mm holes. I would suggest using a pair of calipers to check the holes match that size otherwise this would not work for you unfortunately