Cat Pendant - Katzen Anhänger
Cat Pendant - Katzen Anhänger
Boost
10
9
6
Print Profile(1)
0.2mm layer, 2 walls, 40% infill, supports only on plate
Designer
11 min
1 plate
Open in Bambu Studio
Boost
10
9
6
0
13
7
Released
Description
Cat Pendant - Katzen Anhänger
(Without metal parts / ohne Metall Teile)
Dimensions/Maße: 26x22x4mm (2mm loop/Schlaufe)
Uses about 1.07g of PLA in 1:1 scale. (4.48min)
Verbraucht 1,07g PLA im Maßstab 1:1. (4,48min)
BambuLab PLA Matte, white
Removing the supports after printing could need some polishing after completion because of the small scale.
Die Stützen könnten beim Entfernen Spuren hinterlassen, lässt sich gut entfernen.
I recommend looting some metal ring off of some usb drive laying around for a budget version.
Den Ringe habe ich von einem USB Stick geräubert und die Kette ist preiswerter Modeschmuck.
Have fun <3
Comment & Rating (6)
All
Print Profile
0.2mm layer, 2 walls, 40% infill, supports only on plate
The designer has replied
0
Reply
@dr_dentist2 Thanks a lot, have a nice day.
0
Reply
Print Profile
0.2mm layer, 2 walls, 40% infill, supports only on plate
The designer has replied
0
Reply
@tpfister7512 Thanks for your rating, have a good one!
0
Reply
Print Profile
0.2mm layer, 2 walls, 40% infill, supports only on plate
The designer has replied
0
Reply
@Nessi881 Thanks for rating, I am always open for feedback to improve my work too.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld