light stand cap
Print Profile(1)
Description
if I put my light stand in my car trunk, the end can scratch the wall. I created a snap on cap that prevents this.
It prints without support. I used brim to encourage it not to fall over. should not be a problem to print on either end.
this same cap should work fine on the light stand variation that has a different ends. IF it is in warm car, and the version with the larger center dia. The cap snap might not work as well on the smaller diameter after that. Because it takes a set from the larger.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (3)