Sample Kitty

Tis a sample of one of the pets from my Pumpkin Pets set!! If you want to see the whole set, check out the post linked on this photo:

Legend says that when a pumpkin patch grows especially bright under the moon, little paws will start poking out of the soil. First come the leaves on their chests, then the wiggly tails, and finally—if the pumpkins are feeling playful—their tiny heads will sprout from inside the gourds.

Recommended Print Settings:

• Layer Height: .16
• Infill: 15%
• Supports: Not usually needed, but feel free to add them if your printer prefers a little help.
• Pro Tip: If the first layers struggle to stick, try slowing down the first layers or increasing the bed temperature slightly.

Please be warned that these models are not recommended to be printed for young children, or anyone at risk of a choking hazard. There are small parts that can be broken off if roughly handled. Print at your own risk!

--------------------------------------------

If you like this design, please check out my other models: https://cults3d.com/en/users/StarMouse3D/creations

StarMouse3D creations are protected by copyright. These files are for personal use only, and you do not have the right to sell the files or the models without explicit consent from me.
 

To legally obtain permission to sell PHYSICAL prints you may obtain permission to sell every model as an active Patreon supporter through this link: https://www.patreon.com/c/StarMouse3D

Please do not share digital files! Thank you.