Failed print business card holder
Boost
19
22
4
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
1.4 h
1 plate
Open in Bambu Studio
Boost
19
22
4
2
41
17
Released
Description
There are quite a few holders here inspired by print in-progress coaster but they all seemed a bit too clean to me so I made a bit messier one to show off what printing is all about.
Comment & Rating (4)
All
Boosted
this turned out absolutely amazing thank you
(Edited)
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Amazing little business card holder - perfect for me!
Cards may fall out a bit easy, however.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
works very well
0
Reply
very nice print. used supports. but I should have just re oriented the nozzle print. the filament portion gave me errors but printed fine despite them.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld