Panda Touch Stand

Panda Touch Stand

Boost
18
39
13

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
4.9(13)

Boost
18
39
13
0
116
109
Released

Description

Simple stand for the Big Tree Tech Panda Touch. It uses all for mounting points on the frame and is secured using the screws provided with the Panda Touch.

Comment & Rating (13)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
Great design, thanks very much
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
nice print job with petg cf
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Well designed model, and it printed perfectly. I used a dual extrusion black and white filament with five walls to try and make it as hefty as possible. My initial concern was that it would be so lightweight I can never pull the screen away from the base without lifting up everything as well because the magnets are so strong. In hindsight That's not realistic. Meaning you're just going to have to use both hands if you want to pull the screen away from the base plate.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed amazingly in Bambu Lab PLA and works perfect!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
perfect
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Prints well, great for placing my panda touch on my desk so i can monitor the printers in the garage.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Overall well done.... but the balance was not perfect. It can fall forward with the screen attached.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed several of these and didn’t have an issue.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply