desk organiser with japanese influence

created in fusion 360

photos show printed in matte black pla and brick red petg-cf

• 0.16mm layer height
• 50% gyroid infill (to ensure structural integrity)
• no brims or supports

it's easy to assemble, however be careful with the tabs that connect bottom and top section when inserting to ensure that they don't break as they are quite thin, however hold up perfectly as this was not designed to carry any heavier weight on the small shelf

i also recommend adding a drop of super glue on both the tabs before inserting them into the connection holes, to ensure that it stays well fixed. The shelf is "indented" into the structure for proper placement

3mf includes two plates one with the main components (textured PEI chosen for this one) and the other with the small shelf in PETG (engineering plate is set for this one) as i printed them back to back, feel free to adjust to your plate preference

in my opinion this model pairs very well with my stackable storage box model, as you can see on the photos

If you enjoy using this 3D model and are able to, please consider supporting my work by buying me a coffee. Your contribution goes a long way in fueling future creations. Thank you for being a supporter!

note: all photos uploaded are of the actual printed model, taken inside a lightbox or in natural light on top of a desk / table