Tinkerbel

Please rate if you print, this really helps me, thank you

You can resize the model, but only change the X- and Y-axis NEVER change the Z-axis

FOR A1 MINI USERS, YOU CAN OPEN THE FILE AND REORIENTATE THE HUEFORGE ON THE BUILDPLATE

Please rate if you print, this really helps me, thank you

IMPORTANT THE DESCRIPTION FOR THE THINNER VERSION IS THE BOTTOM ONE IN RED (also in the description in the print profile)

Thicker version

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 53.33x159.99mm in size

You may print at higher layer heights below the Min Depth of 1.3mm
The Max Depth is 3.3mm and the Actual Depth is 3.4mm

Filaments Used:
    PLA PolyLite Black Transmission Distance: 0.3
    PLA Prusament Galaxy Green Transmission Distance: 3.2
    PLA BambuLab Basic Yellow Transmission Distance: 5.9

This print uses 3 unique filaments

Swap Instructions:
    Start with Black
    At layer #17 (1.44mm) swap to Galaxy Green
    At layer #29 (2.4mm) swap to Yellow for the rest.
 

Slimmer version

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 53.33x159.99mm in size

You may print at higher layer heights below the Min Depth of 0.88mm
The Max Depth is 2.3mm and the Actual Depth is 2.4mm

Filaments Used:
    PLA PolyLite Black Transmission Distance: 0.3
    PLA Prusament Galaxy Green Transmission Distance: 3.2
    PLA BambuLab Basic Yellow Transmission Distance: 5.9

This print uses 3 unique filaments

Swap Instructions:
    Start with Black
    At layer #12 (1.04mm) swap to Galaxy Green
    At layer #21 (1.76mm) swap to Yellow for the rest.