Slotcar stand carrera Ständer

Slotcar stand carrera Ständer

Boost
5
6
5

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
13 min
1 plate
4.8(5)

Open in Bambu Studio
Boost
5
6
5
1
14
35
Released

Description

Deutsch:

Damit die Reifen sich nicht unrund stehen, sollten diese am besten immer in der Luft sein.

Dieser Ständer schafft Abhilfe.

Führung für den Leitkiel passt auch für den längeren und breiteren Leitkiel von Frankenslot.

Ständer passt durch die lange Führung sowohl für kurze, als auch für die langen Autos.

Alle abgebildetetn Autos wurden getestet und für gut befunden.

 

English:

To prevent the tires from becoming out of round, it is best to always keep them in the air.

This stand helps.

Guide for the guide keel also fits the longer and wider guide keel from Frankenslot.

Thanks to the long guide, the stand fits both short and long cars.

All cars pictured have been tested and found to be good.

Comment & Rating (5)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
Very nice model, it was easy to print. I had a good result, even as a noob in the 3D printing world.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more