iPhone 13 case with cutout for MagSafe charging
Copyright Claim
iPhone 13 case with cutout for MagSafe charging
Boost
28
48
15
Print Profile(1)
0.1mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
Open in Bambu Studio
Boost
28
48
15
1
177
109
Released
Description
See also a newer version of this case: https://makerworld.com/en/models/44351
Printed on a Bambu Lab X1-Carbon with 0.1 mm layer height, no supports.
For interesting patterns one the case itself, use 3-8 walls, infill of your choice, 0-4 top and 0 bottom layers.
For the camera surround piece I used default settings for infill, and top and bottom layers.
All my models on MakerWorld are free to use and remix. They have a non-commercial license. If you enjoy this or any of my other designs you can send me a small donation using the link below. Thanks :)
Comment & Rating (15)
All
Print Profile
0.1mm layer, 2 walls, 15% infill
Couldn't get it to print that great.
(Edited)The designer has replied
0
Reply
what material did you use and which defects did you see? because of the thin construction some materials work worse than others
0
Reply
Replying to @_hsb_
I used TPU 95A. Overall just a really rough print in some areas around the button areas especially. A lot of stringing too but I know a lot of that is typical when using TPU...
0
Reply
Replying to @Davisinstallati
oh I see, it’s not really designed for TPU. I’ve only used PLA to print it.
(Edited)1
Reply
Boosted
its very good
0
Reply
Print Profile
0.1mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.1mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.1mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.1mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.1mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.1mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.1mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.1mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
© 2024 MakerWorld