Cherry Blossom Coaster Set by britt_3d

britt_3d

Household>Other House Models

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

0.16mm layer, 2 walls, 15% infill

Designer

8.2 h

3 plates

5.0(2)

0.16mm layer, 2 walls, 15% infill

Designer

7.1 h

3 plates

Open in Bambu Studio

Boost

Released

Description

I made some cherry blossom coasters with a holder to store them!

This is a set of 4 coasters and the holder that all sit flush together. I made indentations on the bottom of the coasters to fit rubber feet.

I use these: Pack of 200 Cabinet Door Bumpers - 1/2” Diameter Clear Adhesive Pads for Drawers, Glass Tops, Cutting Boards, Picture Frames, Small Furniture - Amazon.com

I set a mug on a coaster with boiling water for ~20 minutes and small warping occurred so I wouldn't recommend using hot drinks for long periods of time.

If you like what I'm doing, consider buying me a coffee. Much thanks!

Comment & Rating (4)

@ontheriver

Print Profile

0.16mm layer, 2 walls, 15% infill

Soooooo pretty. A bit of clean up needed and the stamens are delicate.. These are large coasters, I am probably going to try printing smaller so that I can put 4 to a plate.