Flask Funnel with Vent
Copyright Claim
Flask Funnel with Vent
Boost
7
14
11
Print Profile(1)
0.2mm layer, 2 walls, 60% infill
33 min
1 plate
Open in Bambu Studio
Boost
7
14
11
1
45
49
Released
Description
Summary
Fairly small funnel that should work in most flasks (Ø10 mm outlet). I have added a vent tube to the side of the funnel to improve the speed of filling without bubbling. Print with large opening down on the build plate.You may want to increase the wall line count if leaking through the funnel occurs.
Print Settings
Printer:
Maker Select V2
Rafts:
No
Supports:
No
Resolution:
.15 - .20
Infill:
40% - 100%
Filament: Hatchbox PLA SIlverComment & Rating (11)
All
Print Profile
0.2mm layer, 2 walls, 60% infill
printed without any problems. maybe a little small. but that can be scared up until it fits.
1
Reply
Print Profile
0.2mm layer, 2 walls, 60% infill
Print itself went very smoothly, used bambu PLA basic
1
Reply
Print Profile
0.2mm layer, 2 walls, 60% infill
failed once but final product turned out great!
1
Reply
printed perfect
1
Reply
Print Profile
0.2mm layer, 2 walls, 60% infill
0.0
1
Reply
Print Profile
0.2mm layer, 2 walls, 60% infill
Came out perfect amd just in time to fill my flask before dealing with my inlaws! :)
1
Reply
Print Profile
0.2mm layer, 2 walls, 60% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 60% infill
1
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 60% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 60% infill
Other Issues:It worked rather less well. The vent is too narrow for a suitable equalization to take place.
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld