LED Remote Stand

_______________________________________________

About:

This stand makes your desktop a little more organized by standing up the LED controller. Normally my LED controller was always scattered around on my desk, so I made this. This Might Not Fit The Remote You Have.

____________________________________________

Steps To Print:

1. Simply Print the 3mf in any color and 1 hour later it should be done!

____________________________________________

Dimensions + Print Time + Filament Used:

• 90mm tall (3.5 inch)
• 85mm wide (3.25 inch)
• <1 hour print time!
• 12g of filament used

____________________________________________

Settings:

• Layer height: .28mm
• Walls: 2
• Top shell layers: 4
• Bottom shell layers: 3
• Infill: 15%

_____________________________________________

Extra:

This May Not Fit Your Remote

More Cool Prints:mwiller | Published - MakerWorld