I had some overhang issues. Most likely wet filament. great print.

Came out pretty good don't need supports but I add them just cause lol.

Very cute and easy to print. I did 2 at one time to reduce waste poop but she got taken by some Jawas.

my daughter wanted a hello kitty figure so I printed this on my X1C with AMS. I used an aftermarket textured build plate for the first time and it's stuck like glue. I took all of the filament out of my AMS and lined up the colors the way it was showing up on the slicer but I changed the dress to a pink color for the bluish slot. it came out perfect. The only reason I don't like to do multicolor prints is because it takes much much longer. I know there's a way to reduce purge time and speed up the print when doing multicolor but I don't know how to adjust for that. using my 0.4 mm nozzle at a 2mm layer height or took about 10 and a half hours. I believed it used a gyroid infill at 5%. I just wish I would have made it larger since it was going to take so long anyways it only would have added a couple hours to make this large. it also had tree supports added around the bottom and then three tall spots in the front. I think I probably could have not went with supports and the print would have been fine but it was built into the file. I guess I could have downloaded the raw file but then I would have had to paint everything in the slicer. overall I'm satisfied, just wish it didn't take so long but I don't think that's the makers fault.

Cute overall print around the face came out a little rough

I gave it to my mom because it was her birthday (: