Print Profile(1)
0.2mm layer, 2 walls, 30% infill
Designer
6.1 h
1 plate
Open in Bambu Studio
Boost
13
18
4
1
47
16
Released
Description
Laptop holder for upright stand. It helps you to hold the laptop in vertical position when used as a second monitor.
It can hold laptop with the thickness of maximum 2 cm.
It is sturdy and very hard to flip over.
Comment & Rating (4)
All
Print Profile
0.2mm layer, 2 walls, 30% infill
No problems at all!
1
Reply
Many laptops have a piece of rubber on the bottom on the front side. It'd be great if there was a cutout in the stand to accomodate for this. Now a lot of laptops don't fit in this stand.
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
printed perfectly.
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld