These parts were all purchased by me online. You can try searching for them.stainless steel bead(diameter4mm) shaft pin(diameter2mm length10mm) shaft pin(diameter1mm length11mm and 9.5mm) The first two may be easier to buy, while the last one may not be available. I will upload some new models and try to use some simple and easy to make parts as much as possible
Other Issues:took 3 hours to get ams to load filament. user interface is sketchy, send to printer/print comman ambiguous and weird. you need an obvious print button selection. P1S is not a plug and play, setup and go 3D printer. I am very disappointed in its finicky not well thought out design of hardware and software.
Seems you’re rating the Bambu ecosystem here? this rating is meant for a single print profile so your concerns are likely buried and not discoverable by who you want to listen.