Cupholder for Citroen BERLINGO 2 (2008-2018)

Copyright Claim

Cupholder for Citroen BERLINGO 2 (2008-2018)

Boost
3
5
0

Print Profile(0)


Add the first print profile to earn points

Boost
3
5
0
0
13
0
Released

Description

After i spent some time while finding ideal cupholder for my work vehicle Citroen Berlingo 2, i had to make my own 3D model, because none of them was ideal for my concept of use.

 

 

This cupholder is located under the shift knob and can take up to 2 cups. This is overall third version and it is in my opinion the best solution for how to fit 2 cups cupholder in this specific placement. I also provide radius scheme of used pocket in car (last image), so you don't have to measure it in order to make your own version of cupholder or some other accesories for this space.

 

PRINT SETTINGS:

i printed with:

  • 20% infill
  • 3 walls
  • without supports, brim or raft,…
  • printed from PLA and so far survived 1 whole summer in Czech Republic, but for better heat ressistance you can use PETG
  • 0,28 layer took about 12 hours and 120g of filament (Cura, tuned E3 PRO)

TECHNICAL DESCRIPTION:

  • 2x 70mm holes for cups
  • 50mm deep
  • radius is 7mm for 82mm distance (shown on last image)
  • fixed in place only by sliding it in the pocket, if you want more rigidity, use some double-sided tape
  • does not colide with shift knob while shifting, othervise, it can slightly colide with handbrake, but if you are gentle, it's not that big deal

Comment & Rating (0)

Please fill in your opinion
(0/5000)

No more