Sunlu S2 Filamenttrockner PTFE-Schlauch
Copyright Claim
Sunlu S2 Filamenttrockner PTFE-Schlauch
Boost
62
127
56
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
11 min
1 plate
![0.16mm layer, 3 walls, 15% infill [A1 mini]](https://makerworld.bblmw.com/makerworld/model/USf36a7eaf5f3aa2/design/2023-12-08_f3304732041b4.jpg?x-oss-process=image/resize,w_100/format,webp)
0.16mm layer, 3 walls, 15% infill [A1 mini]
11 min
1 plate
Open in Bambu Studio
Boost
62
127
56
1
277
216
Released
Description
Sunlu S2 Filamenttrockner PTFE-Schlauch
PTFE Tube für Filament, was sich in alle Richtungen bewegen kann, kann erstellt werden.
Der Adapter nimmt einen PTFE-Schlauch 4x2 mm auf. Dies wird ca. 5cm ins Innere geschoben und ca. 10 cm bleiben außen (kann aber nach belieben geändert werden, kürzer oder länger).
siehe Bilder
Montage:
Das kleine PTFE-Stück entfernen und danach kann man den Schlauch mit PTFE einsetzen.
Es ist auch egal, ob das Filament von oben oder unten von der Rolle durch den PTFE-Schlauch geschoben wird, beides funktioniert sehr gut.
erstellt in Fusion 360
Comment & Rating (56)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
passt exakt mit PLA basic von Bambu Lab
The designer has replied
0
Reply
Danke
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed with Sunlu PLA+ and I am very happy with the result. Thank you for your work!
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill [A1 mini]
fits perfectly
0
Reply
Perfect. you have to remove a small piece of ptfe which is in the hole of the S2 so that it fits and it's great
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Print profile and model ok.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice simple 5 minute print
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed excellent and in less than 5 Minutes.
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Works perfect :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed fine but its to big will not fit into machine
The designer has replied
0
Reply
Hallo, dann würde ich den Drucker mal Kalibrieren.
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
nice good!
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld