Search models, users, collections, and posts
Hole calibration
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
Open in Bambu Studio
Boost
2
4
0
0
13
6
Released
Description
I needed to produce well-fitting parts and found that the variations in X & Y were off, so I designed this to accept a nominal hole id Ø (3mm/4mm/5mm/6mm) with offsets of -0.2mm/+0.2mm/+0.4mm so that I could adjust my settings accordingly.
On my A1, I found that PLA Tough (grey) was -.0.1mm from nominal in the Y-axis and -0.2mm in the X-axis using the BL supplied profile. Using PETG Basic (yellow), the Y-axis was correct to 0.02mm (the accuracy of my callipers) over three measurements. The X-axis was 0.1mm.
Simply print using your material and settings, and measure. Beware of the hole edges flaring, and deburr before measuring if necessary.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)