Search models, users, collections, and posts
Bitholder
Remixed by
IP Report
Print Profile(1)
0.24mm layer, 2 walls, 15% infill
Designer
2.5 h
1 plate
Open in Bambu Studio
Boost
4
6
0
0
3
1
Released
Description
Content has been automatically translated.
• Kevin's 3D Print Profiles
• Print Settings for PETG & PLA
• Fine-tuning for perfect prints
• My Makerworld Print Setups
Boost Me (for free)
I only slightly reworked the surface so it no longer looks quite so static
Original Source: Dremel Bit Holder by RGN01 - Thingiverse
"This profile has been tested multiple times. For best results: a clean bed, good filament, and a little patience."
Boost Me (for free)
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)