AMS Side External Spool Holder
Copyright Claim
AMS Side External Spool Holder
Boost
7
5
10
Print Profile(1)
0.2mm layer, 4 walls, 25% infill
Designer
1.7 h
1 plate
Open in Bambu Studio
Boost
7
5
10
1
23
26
Released
Description
I designed this external filament spool holder. It is designed to slide inside the edge of the Bambu AMS unit.
New Rev is 1.3 where I narrowed the tab that fits into the AMS side to 8mm… This will hopefully resolve the issue of the spool fitting too snugly into the side of the AMS.
Enjoy!
Comment & Rating (10)
All
Print Profile
0.2mm layer, 4 walls, 25% infill
Printed just fine. Black PLA. No issues inserting into the bottom of the AMS, slide right in and holds spool well.
The designer has replied
1
Reply
Glad to hear! thank you!
0
Reply
Just printed and tried to install on my P1S and AMS. Part is way too thick to fit into the AMS, If I pushed any moreit would have broken. Binned my print. Thin out even more and it may work.
The designer has replied
1
Reply
Thank you for your feedback. I narrowed the tab down to 8mm so it should clear the AMS side without issue.
My sincerest apologies for your inconvenience and wasting the model.
0
Reply
Replying to @OldGregg
No worries, it comes with the territory of 3d printing.
0
Reply
I feel like it could be a bit slimmer where you attach the spool holder I can see the stress marks around where I installed mine
The designer has replied
1
Reply
yeah… I slimmed it down for the latest upload. I may need to revisit this again.
I appreciate your feedback. cheers!
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld