Container with screw lid by Jakes3dPrintShop

Jakes3dPrintShop

Household>Other House Models

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 3 walls, 15% infill

Designer

2.3 h

1 plate

4.9(16)

Open in Bambu Studio

Boost

222

173

Released

Description

Just another screw top container. There are some other good ones, but I needed this exact size and scaling doesn't always work the best with screw tops. I made this container for my daughters slime. She loves making slime and this fits perfect. It holds almost exactly 8 oz. (236.588ml) of water (that was pure accident). The top screws on in less than 2 full turns which is really nice. The picture shows with random seams. I didn't like that, so I uploaded a profile with aligned seams.

Comment & Rating (24)

@Better_Printer

Print Profile

0.2mm layer, 3 walls, 15% infill

Works just like a container with a good tightening feature. Thanks!

The designer has replied

@Jakes3dPrintSho

thank you for the review. much appreciated

@user_1915132127

Print Profile

0.2mm layer, 3 walls, 15% infill

Printed a couple without any problems at all! Used pla for all prints all are printed on the textured pei plate.

The designer has replied

@Jakes3dPrintSho

They look great. Thanks for the review!

@nathan_b

Print Profile

0.2mm layer, 3 walls, 15% infill

Printed great. Looks fantastic.

@brianco67

Print Profile

0.2mm layer, 3 walls, 15% infill

Used PA6-CF and had a lot of layer change blobs, but probably my fault. not my fault is that the cap was too small to thread. might want to go 101% on the lid size.

The designer has replied

@Jakes3dPrintSho

that may be an issue with the filament. idk. fits perfectly for me otherwise I wouldn't have uploaded it. can you try plain pla and use my profile and see if you get different results

@brianco67

Replying to @Jakes3dPrintSho :

You are right. I was new to PA6-CF and I think I messed up the default settings by accident. Printing this in PETG was perfect and the lid fit just fine.

(Edited)