Holsters:

• Remove the support after printing (green part in the picture)
• If you need additional supports because of the bridging, be careful as the parts may break when you remove them
• Holsters are simply attached to the leg
• The holsters are fragile. Apply them carefully!

Slide the head into the mask and press it in with gentle force on the chin.

If this is not possible, it is probably due to the following points:

• Check the inside of the helmet (the top) to see if it has been printed cleanly and remove any filament debris that is sticking out
• Has the brim been removed cleanly?
• The elephant foot can cause the inner rim to be a little too narrow, just sand the inner rim down a little or work it with a knife

Logo:

The logo can be snapped onto the armor