Mindflayer Illithids pack dnd miniatures
Remixed by
Copyright Claim
Mindflayer Illithids pack dnd miniatures
Remixed by
Boost
48
92
13
Print Profile(1)
0.12mm layer 0.4mm nozzle
Designer
3.5 h
2 plates
Open in Bambu Studio
Boost
48
92
13
2
101
75
Released
Description
remixed, put on nice bases with holes in them where you can put a magnet for easy storage
If you enjoy this model, please consider boosting it.
| My DnD miniatures | ||
|---|---|---|
|  |  |
 |  |  |
 |  |  |
 |  |  |
All my models | ||
Comment & Rating (13)
All
Print Profile
0.12mm layer 0.4mm nozzle
I printed all three with varying success. The middle one worked great, but the left one's face tenticles broke off when removing supports. The right one's hands and spear broke off. As well as the tentacles on the right one. The issue is when the face tenticles aren't connected to the rest of the model. This is definitely particularly my fault for having the separation be 0.1 mm though.
0
Reply
Print Profile
0.12mm layer 0.4mm nozzle
(Edited)
0
Reply
Boosted
Print Profile
0.12mm layer 0.4mm nozzle
the supports are a bit difficult to remove but totally worth it
0
Reply
Print Profile
0.12mm layer 0.4mm nozzle
Broke
(Edited)0
Reply
Print Profile
0.12mm layer 0.4mm nozzle
Came out clean and nice for me, even on the 0.4 nozzle! Cheers!
0
Reply
Print Profile
0.12mm layer 0.4mm nozzle
Very cool!
0
Reply
Print Profile
0.12mm layer 0.4mm nozzle
good model and very detailed
0
Reply
Print Profile
0.12mm layer 0.4mm nozzle
Surprisingly sturdy and solid. Tree supports were very easy to remove.
0
Reply
Print Profile
0.12mm layer 0.4mm nozzle
great little print
0
Reply
Print Profile
0.12mm layer 0.4mm nozzle
Only printed one model due to time constraints however was very satisfied, will print the trident one soon
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld