DeWALT with Lady Light Box / Wall Art
Boost
9
14
2
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.7 h
2 plates
Open in Bambu Studio
Boost
9
14
2
0
16
9
Released
Description
DeWALT Light box
As with all sharp corners and round nozzles. You may need to trim the edge to get cover to fit.
I normally print with AUX fan OFF to prevent warping
Design for P1S, scaling down may not have good results
For Commercial Rights To This Model:
https://www.patreon.com/Tri_3D
Comment & Rating (2)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
small defect on the white part, will try again and adjust my rating. the walls seems a little soft but it cost less filament
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld