Voronoi Pencil Holder by humebeam

humebeam

Tools>Organizers

Print Profile(4)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.4mm nozzle, 0.2mm layer, 2 walls, 10% infill

Designer

2.7 h

1 plate

4.3(95)

0.2mm nozzle, 0.1mm layer, 4 walls, 10% infill

Designer

8.1 h

1 plate

4.0(2)

0.6mm nozzle, 0.18mm layer, 2 walls, 15% infill

2.1 h

1 plate

5.0(1)

Orange PLA

2.1 h

1 plate

Boost

158

339

109

946

700

Released

Description

If your printer and filament is not dialed in perfectly don't even attempt to print this model, it's not an easy print.

Support

All my designs and mods are free to use and remix. They have a non-commercial license. If you enjoy this or any of my other designs you can send me a small donation using the link below. Thanks :)

https://www.paypal.me/humebeamengineering

About

Everyone loves a good Voronoi diagram. So I made a pencil holder that prints without supports with minimal cleanup required, depending on printer and filament type. It does not use a lot of filament.

Print Settings

I recommend printing it in PLA as there are some challenging overhangs where it's beneficial with maximum parts cooling but it could print nicely in other filament types as well.

I've printed a couple on my Bambu Lab X1C and P1P printers and they printed very nicely in Prusament PLA without supports in around 2 hours and 20 minutes using 31g of filament.

Comment & Rating (109)

@mcclanelocock12

this print was amazing it didn't take that long

@koliploik

The print profile is no longer public

unfortunately print failed in multiple points.. 0.6 nozzle with polyterra PLA.

The designer has replied

@humebeam

I had no issue printing this profile with a 0.6 nozzle. That said, it's a challenging model to print due to all the small sections. I have removed the profile for now until I am able to reprint it.

(Edited)