Keychain Container Small Pill Bottle with Threaded Cap and Knurled Body
Copyright Claim
Keychain Container Small Pill Bottle with Threaded Cap and Knurled Body
Boost
55
100
29
Print Profile(3)
0.2mm layer, 2 walls, 10% infill
Designer
1 h
1 plate
A1 Mini - 0.2mm layer, 2 walls, 10% infill
1.5 h
1 plate
0.32mm layer, 3 walls, 8% infill
1 h
1 plate
Open in Bambu Studio
Boost
55
100
29
2
162
162
Released
Description
A handy little container with a threaded cap and knurled body design
I personally use mine for my medication for ease of use when I'm out, or as a backup in case I forget them at home, its came in perfect and handy when I've been away from home.
Of course you can store and carry whatever you like
My GF uses this one to carry her little portable fragrance bottles in her bag
It can be resized, just make sure to resize both parts the same
I use .2 layer, .4 nozzle, 2 walls, 10% + infill, but you can use your own settings
Mine prints without supports and it bridges just fine on the inside of the cap, but you can support it if you like
Comment & Rating (29)
All
Boosted
Print Profile
0.2mm layer, 2 walls, 10% infill
Clean Print, works great
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
perfect print first time
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Second one I have made and both came out great. A nifty design and now my wife will have a container to take medicine so she doesn’t forget and leave it at home. Great job and thanks for the share
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Fast perfect print no issues. Good work
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
A1 Mini - 0.2mm layer, 2 walls, 10% infill
It looks very nice, the neck however is a bit weak and easy to break
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Printed well. thanks!
0
Reply
Print Profile
A1 Mini - 0.2mm layer, 2 walls, 10% infill
Top needed a little work in the threads
0
Reply
I liked your first version better with the ring between the cap and bottle. That way i can make the ring out of tpu giving a fully waterproof design.
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Added supports for keychain loop as the bridged section ended up being too weak
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld