Mugstacker - Becherstapler by Kirumi

Kirumi

Tools>Other Tools

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

44 min

1 plate

4.0(2)

Open in Bambu Studio

Boost

Released

Description

This was my first created model, due we have so many cylindrical mugs which cant be stack very well.

So here is the solution, the designe will fit to the most mugs I have tested so far.

I have try to print it with out support but have no success may be you can do it with out but I don't recommend to do so.

Used Material:
Bambu Basic PLA (green)
Bambu Support for PLA

kitchen

Comment & Rating (4)

@Enno1

Print Profile

0.2mm layer, 2 walls, 15% infill

Support Issue:stützen gehen schwer ab

The designer has replied

@Kirumi

Hast du es mit Support Material gedruckt oder ohne? Wenn du Verbesserungsvorschläge hast, immer her damit :)

@Enno1

Nur mit PLA (kein Support Filament zu Hause ) werde mal testen mit PLA nen Support einzustellen das man kein Support Filament braucht. Nach ca 20 min habe ich es aber lose bekommen. Die Form passt aber perfekt.

@jweldridge04

Print Profile

0.2mm layer, 2 walls, 15% infill

No more

License

This user content is licensed under a

Creative Commons Attribution-Noncommercial-Share Alike

Related Models

maCStacker Ender-3 Lack Enclosure

maCyo42